Fardriver ND72300 Controller
The ultimate power upgrade for your electric scooter. Engineered for high-voltage builds, custom tuning, and extreme performance. Unlock higher top speeds, massive low-end torque, and smooth, precise throttle response.
The Fardriver ND72300 is a high-performance, sine-wave FOC controller designed for 72V electric motorcycles, scooters, and custom EV conversions. Supporting hub and mid-drive motors with a peak phase current of 300A, it delivers smooth, quiet acceleration and features an IP67 waterproof rating. The controller includes a main wiring harness, mounting hardware, and a Bluetooth module for wireless smartphone tuning of throttle curves, current limits, and regenerative braking. Built-in protection guardrails monitor for over-voltage, over-current, and over-temperature faults to ensure safe operation. Professional installation is recommended to properly match the controller with your motor and battery BMS specifications.
Unleash the full potential of your e-scooter's motor. This controller features advanced VESC®-based architecture, allowing for complete customization of your ride dynamics. Whether you are running a high-voltage battery upgrade, looking for a higher top speed, or tuning for maximum acceleration, this ESC delivers. Supports both FOC (Field Oriented Control) for silent, efficient cruising, and BLDC modes.
Compatible with a wide range of electric scooter motors (including dual-motor setups and single-motor hub drives). Recommended for DIY builders and tuning enthusiasts. Always ensure your battery's BMS can handle the output current and verify phase wiring configurations before your first test ride. Keep your firmware updated via the VESC Tool for optimal stability."
Engineered for High-Speed Tuning
Take control of your scooter's power curve. From field weakening for higher top speeds to fully adjustable regenerative braking that saves your brake pads, this controller provides the ultimate electronic upgrade for demanding riders.
▶️ Installation Guide ✨
⚠️ IMPORTANT SAFETY NOTE: Custom controller installation requires a basic understanding of electronics, soldering, and wiring dynamics. Always disconnect your battery before working on your electric scooter's internal electronics.
How to Use FSESC 75100 Pro with Alu PCB for E-Scooter丨FLIPSKY
FLIPSKY
How To Wire & Setup Any VESC Controller
Woky
I VESC'ED MY KUKIRIN G2 2025
Addi Chavez